Rotational biomechanics of the golf swing have been identified as important determinants of power generation, driving distance, and injury prevention [1-3]. In particular, the orientation of the pelvis and upper torso has been used as a measure of performance that can guide injury prevention [4-10]. The X-factor, defined as the relative angular position of the pelvis and upper torso, has been shown to influence power generation and to be more highly consistent in professionals compared to amateur golf swings. Benchmark curves of angle of rotation of the pelvis, upper torso, and X-factor were reported in a cohort of 10 professional golfers throughout the golf swing and in relation to phases of the golf swing [11]. However, recent evidence has suggested that rotational velocities of the golf swing are also critical to performance and therefore can provide a basis for strategic training and injury prevention [9,12]. Since power is defined as the product of velocity and force, or angular velocity×moment, evaluating golf swing rotational velocities can provide insights into power generation, performance, and proper swing biomechanics. We hypothesized that shoulder and pelvis angular velocities would be highly consistent in professionals. Further, we sought to evaluate different velocities at impact or peak magnitude between professional and amateur golfers.

Golf is a popular sport with approximately 30 million people who play at least once per year in the United States, 68% of who are 30–60 years old and 37% who are over 60 years old [10,13]. Around the world, over 55 million people play golf. Although golf sustains lower injury risk compared to contact sports, a successful swing is difficult to achieve and poor swing dynamics can lead to injury [13-15]. Low back pain is one of the most common injuries associated with golf. It represents 26%–52% of all symptoms [6,14,16,17].

Mechanisms of injury tend to arise from either overuse, primarily in professionals, or trauma and improper swing biomechanics, primarily in amateurs [17-22]. Prior studies suggest that rotational biomechanics may play an important role in both preventing and treating low back pain. Improper rotational biomechanics have been shown to increase the torque, shear, and lateral-bending forces experienced by the lumbar spine in professional golfers [6,23,24]. Understanding rotational biomechanics of the professional and amateur golf swing can provide a basis to improve performance and decrease injury for the growing population of golfers around the world.

Several prior studies have investigated rotational biomechanics of the golf swing, including rotational velocities; however, rotational velocity throughout all phases of the golf swing has not been well studied. Zheng et al. [9,12] examined angular velocity during down swing and concluded that ability to maintain separation between upper torso and pelvis segments appeared to generate higher angular velocity in professional golfers. Similarly, Myers et al. [25] reported rotational velocities of 100 recreational golfers during low, medium, and high velocity swings and found ball velocity was significantly correlated with both upper torso rotational velocity and the relative velocity of the upper torso and pelvis (X-prime). Among recreational golfers, peak upper torso and pelvis rotational velocities exceeded 700 and 400 deg/s, respectively, demonstrating the extreme rotational dynamics of the golf swing. Horan and Kavanagh [26] evaluated forward tilt, lateral tilt, and axial rotational velocity of the head, trunk, and pelvis during the down swing portion of the golf swing of professional golfers. They demonstrated that the trunk had the highest peak velocities and found a high correlation between trunk and pelvic velocity. These prior studies have evaluated rotational velocities at specific points or periods during golf swing, which provide key insights into parts of the golf swing but cannot be used for benchmark comparisons to evaluate pattern of rotational velocities over the entire swing. This research is one of the first studies to assess consistency of rotational velocity over the entire golf swing.

The purpose of this study was to examine rotational velocity throughout the golf swing and in relation to phases of the golf swing among professional golfers, and to compare these benchmark curves to a sample of amateurs. Specifically, we measured the magnitude and timing of upper torso, pelvis, and X-prime angular velocities and hypothesized that these angular velocities would be highly consistent in professionals and differ at impact and in peak magnitude between professional and amateur golfers.

The basic marker system used in this study was able to characterize the position, velocity, and global orientation of the upper torso and pelvis in professional and amateur golfers (Fig. 2). The kinematics of the hard swing of professionals was consistent between individuals and provided a baseline for comparison with amateur golfers. Upper torso position, pelvic position, and X-factor demonstrated similar patterns in professionals and amateurs when normalized to the golf cycle (left column in Fig. 2). During back swing, the upper torso rotation preceded the pelvis with a greater total rotation, followed by a rapid rotation of the pelvis and upper torso during down swing. The X-factor, or relative rotation between the upper torso and pelvis, was positive throughout back swing, down swing, and at impact. The S-factor, or tilt of shoulders, the O-factor, or tilt of the pelvis, and club head height during golf swing are also graphed, as previously reported [11].

Rotational velocities of professionals were relatively consistent between individuals and provided a baseline for comparison with amateur golfers (center column in Fig. 2). The coefficient of variation (COV) of rotational velocity of professional swings was relatively low, particularly for upper torso and pelvic rotational velocity during down swing (Table 2). Upper torso and pelvic rotational velocities and X-prime exhibited peaks before and after impact.

Peak upper torso rotational velocity occurred in followthrough was significantly reduced in amateurs compared to professionals (p=0.005) (top row in Figs. 2, 3) and differentiated professionals from most (4/5) amateurs. Upper torso rotational velocity during down swing or at impact was not significantly different between amateurs and professionals. In contrast, peak pelvic rotational velocity occurred in down swing. Average pelvic rotational velocity at impact was significantly lower in amateurs compared to that in professionals (p=0.019) (center row in Figs. 2, 3) and differentiated professionals from most (4/5) amateurs. More experienced amateurs (handicap of 4 and 15) had similar pelvic rotational velocity as professionals during down swing, but had reduced pelvic rotational velocity at impact.

In professionals, X-prime, or the relative rotational velocity of the upper torso and pelvis, remained near zero during back swing and increased during down swing. Xprime demonstrated a pattern of two peaks, one peak occurred in down swing just prior to impact and a second larger peak during follow-through, just after impact. In amateurs, X-prime was variable during down swing and at impact; peak X-prime occurred during followthrough, was significantly lower compared to professionals (p=0.005) (bottom row in Figs. 2, 3) and differentiated professionals from most (4/5) amateurs.

Rotational velocities of professional’s easy, medium, and hard golf swings are shown in Fig. 4, along with average values for amateur hard swings. Amateurs exhibited rotational velocities that were similar to the easy golf swing for professionals. Professionals increased both upper torso and pelvic rotational velocities during down swing, impact, and follow-through as they increased swing speed from easy to medium to hard. Rotational velocity of the upper torso, pelvis, and X-prime were significantly correlated with club head velocity at impact with average correlation coefficient (R²) of 0.48, 0.48, and 0.44, respectively (p<0.05).

We analyzed angular velocity of the upper torso and pelvis throughout the golf swing and in relation to phases of the golf swing, and compared these benchmarks between professional and amateur golfers. We found that professionals demonstrated consistent patterns of upper torso and pelvic rotational velocities throughout the golf swing. Rotational velocities demonstrated a unique pattern with two peaks occurring before and after impact, with a slight reduction in rotational velocity at impact. Upper torso angular velocity demonstrated a greater range than pelvic rotational velocity during the golf swing in both professionals and amateurs. In professionals, peak pelvic velocity occurred just prior to impact and peak upper torso velocity and X-prime occurred just after impact. Peak upper torso rotational velocity occurred in follow-through, was reduced in amateurs compared to professionals, and differentiated professionals from most amateurs. Peak pelvic rotational velocity occurred during down swing. Pelvic rotational velocity at impact was significantly lower in amateurs compared to professionals, and differentiated professionals from most amateurs. Peak X-prime was significantly reduced in amateurs compared to the professionals, and differentiated professionals from most (4/5) amateurs. The ability to record relevant upper torso and pelvic rotational velocities using this basic model has positive implications for real-time assessment of rotational velocity of golf swing using inertial sensors outside a laboratory setting.

While professionals maintained upper torso angular velocity during follow-through, in amateurs, upper torso angular velocity dropped rapidly after impact (Fig. 2). Amateurs appeared to stop their swing abruptly after impact, whereas professionals continued to finish swings, indicating that professionals had more continuous and fluid rotational mechanisms. Prior studies that examined only the down swing, reported that maximum club head velocity and peak upper torso rotational velocities occurred near the end of down swing before impact [9,26]. In contrast, the current study found that peak upper torso rotational velocity occurred just after impact and was substantially higher (e.g., 929 deg/s) compared to the study (491 deg/s) of Horan and Kavanagh [26]. These findings suggest that modulation of upper torso rotational velocity during follow-through may have important implications for performance training and injury prevention.

Pelvic rotational velocity at impact was significantly lower in amateurs compared to professionals. Low handicap golfers had pelvic rotational velocities similar to professionals, while the golfer with handicap of 30 and two novices had slower pelvic velocities. In follow-through pelvic velocity was not significantly different between pros and amateurs. Zheng et al. [9] reported that peak pelvic rotational velocity occurred at impact. In contrast, the current study found that peak pelvic rotational velocity occurred just prior to impact. The peak pelvic rotational velocities during down swing in this study were similar to the previous reported results of professionals from Horan and Kavanagh [26] (415 deg/s vs. 464 deg/s).

The current study is the first to describe the kinematic factor of ‘X-prime’ defined by a relative rotational velocity of the upper torso and pelvis, throughout the golf swing. The results demonstrated that X-prime remained close to zero during the early phases of the golf swing and demonstrated a rapid increase before impact. The magnitude of X-prime at impact in the professional golfers was slightly reduced compared to results reported by Myers et al. [25] in recreational golfers (e.g., 170 deg/s vs. 272 deg/s at impact). While X-prime did not differentiate the highest performing amateur from professionals during all phases of the golf swing, there was a significant and distinguishing difference in follow-through (Figs. 2, 3). The difference in X-prime in follow-through arose primarily from differences in upper torso angular velocity during follow-through and suggests that maintaining faster upper torso angular velocity during follow-through may be a distinguishing feature of the professional golf swing.

Peak upper torso rotational velocity occurred just after impact (>1,000 deg/s in pros and 600 deg/s in low handicap amateur golfers) (Fig. 2). Amateurs’ hard swing showed similar upper torso velocity as Professionals’ slow swing. These findings suggest that a rapid upper torso rotational velocity and X-prime during followthrough may be important elements of optimal swing mechanics. In the current study, upper torso and pelvic rotational velocity and X-prime demonstrated a linear increase from slow to medium to hard swings. Meister et al. [11] previously reported a linear increase in peak upper torso rotation angle from slow to medium to hard swings, but did not report on rotational velocity, in an over lapping cohort. These findings suggest that upper torso rotation during follow-through phase of the golf swing likely contributes to power generation and to a smooth swing pattern that may prevent injury, and thus may warrant specific training strategies.

The eleven professional golfers examined in the current study demonstrated consistent rotational velocity swing patterns that allowed for the generation of normal benchmark curves, based on hard swing kinematics, normalized to the golf swing cycle. Benchmark curves generated from the consistent golf swing of professional golfers can guide swing modifications for individualized training to provide milestones for performance while preventing injury.

Previous studies have reported that poor golf swing mechanics are one of the leading causes of golf-related injuries, especially for amateur players [21,22]. Low back injuries are one of the most prevalent injuries in golf [21,27] and have been shown to be related to an excessive X-factor [23,28]. Benchmark curves can provide important guidelines and feedback that can be used to prevent excessive rotation and risk of injury, while optimizing performance. We found that while rotational velocity was lower in our sample of amateurs compared to pros, upper torso rotational velocity exhibited an abrupt decrease after impact compared to pros. This suggests that modulation of upper torso rotational velocity during the entire golf swing may be an important factor to consider to achieve a smooth swing pattern, both for performance as well as injury prevention in amateur golfers. A precise understanding of the optimal rotational biomechanics during the golf swing may guide swing modifications to help prevent or aid in the treatment of injury [29,30].

The current study was limited in that data were necessarily collected in an indoor environment where the true outcomes of shots were unknown. Use of a plastic ball might have affected conditions at impact. The study was designed to determine factors that may contribute to power generation and injury prevention, as indicated by rotational velocities of professional in relation to club velocity at impact, a commonly used measure of power generation, but not actual driving distance [5,8]. Additionally, only male golfers were included in this study, and similar benchmark curves for female professional golfers are needed and would provide insight into differences in rotational biomechanics. An ideal men’s golf swing should not be generalized for female golfers [3,12]. We tested golfers using a 5-iron club and prior studies have reported that peak and impact club head velocities vary with different types of clubs, and may influence rotational biomechanics [7].

In conclusion, data from this study supports our hypothesis that golf swing rotational velocity of the upper torso and pelvis are consistent in professionals. Further, we found that there were common differences between professionals and amateurs with a range of skill levels that may be useful for coaching. Golfers with lower handicaps demonstrated rotational velocities closer to professionals. Benchmark curves derived from consistent angular velocities of pros can be used as guidelines for golf swing injury prevention and performance training. While rotational velocity was lower in amateurs compared to pros, upper torso rotational velocity exhibited an abrupt decrease after impact, in contrast to pros. This suggests that modulation of upper torso rotational velocity may be an important factor in achieving a smooth swing pattern for both injury prevention and performance in amateur golfers. An advantage of this methodology is that only a limited number of markers (n=5) were required for motion analysis and similar methods could be applied using inertial sensors or other wearable technology. Further study is required to develop training strategies that can effectively improve patterns of upper torso and pelvic rotational velocity and X-prime in amateur golfers.